Fitter/Welder TIG and Flux

If you work a Full 80 hours in your 1st two weeks on assignment you can be eligible to receive a $25 QuikTrip gift card!!!

Company out in Sand Springs looking for experienced Pipefitter/Welders

Shift: 6:00am-4:30pm Monday-Friday

Pay: $25-$30 per hour DOE

Education/Experience

• Ability to pass ASME Code Section 8 Welding test 2" schedule 160 carbon, 6G pipe test. GTAW (TIG) all the way out. FCAW (Flux core)
• High school diploma/GED
• 2 year technical degree or vocational certificate in welding preferred
• 4-5 years of relevant experience and/ or training
• Read and interpret blueprints and having strong mathematic skills
• Ability to use and read level, tapes, protractors, and various measurement tools
• Strong organizational skills
• Excellent written and verbal communication skills
• Ability to work independently on assigned tasks

Butt Weld Qualification (GMAW/FCAW Plate) Test

1. The plates are to be 3/4" thick. The 2 plates shall be 4" wide and 8" long.

2. The test will be 3G open root test with 1/8" gap min.

3. Root is open root and must be flush to 1/8" penetration

4. After plates are fit and tacked in an upright position, it may not be moved from this until test is completed.

5. Weld the root with .035" E70S-6 gas metal hard wire (DOWNHILL)

6. If visually accepted by Welding Supervisor/QA Inspector will allow you to proceed with fill and cap the remaining coupon with .045" E71T1 (UPHILL) on vertical test.

7. There is a 1-hour time limit on completing test

8. If the final acceptance by Plant Manager passes visual exam by code, then put initials & position on plate away from the weld.

9. An X-Ray & mechanical test will be done to determine if it is acceptable

Job Type: Full-time

Benefits:

• Dental insurance
• Health insurance
• Vision insurance

Powered by JazzHR